Ajhg: Created page with "Category:Tools Category:Welding thumb This is a tubing washer designed at Carleton in the spring of 2023. It uses drill chuck brushes and 24vdc motors to scrub the surface of rectangular steel tubing. A nozzle at the tubing entrance sprays a mixture of water and a surfactant onto the tubing, and a nozzle at the end rinses everything off. {{#widget:FusionViewer|fusionLink=https://carleton40.autodesk360.com/shares/public/SH28c..."

2026-05-11T17:32:44Z

Created page with "Category:Tools Category:Welding thumb This is a tubing washer designed at Carleton in the spring of 2023. It uses drill chuck brushes and 24vdc motors to scrub the surface of rectangular steel tubing. A nozzle at the tubing entrance sprays a mixture of water and a surfactant onto the tubing, and a nozzle at the end rinses everything off. {{#widget:FusionViewer|fusionLink=https://carleton40.autodesk360.com/shares/public/SH28c..."

New page

[[Category:Tools]]
[[Category:Welding]]
[[File:PXL 20240509 135210685.jpg|thumb]]

This is a tubing washer designed at Carleton in the spring of 2023. It uses drill chuck brushes and 24vdc motors to scrub the surface of rectangular steel tubing. A nozzle at the tubing entrance sprays a mixture of water and a surfactant onto the tubing, and a nozzle at the end rinses everything off.

{{#widget:FusionViewer|fusionLink=https://carleton40.autodesk360.com/shares/public/SH28cd1QT2badd0ea72b50f898d226f521be}}

=== Instructions (draft): ===

==== Before using: ====

* Make sure the fume hood is plugged in, turned on, and the filter media is properly installed.
* Always wear safety glasses to protect your eyes from molten solder and flying debris while soldering.

==== While using: ====

* Place the workpiece into the fixture, or if the workpiece is too large, place it near the front opening of the hood.
* Place the soldering pen holder near the opening as well, to capture any fumes released when not in use.
* When soldering, keep the pen and work close enough to the hood that fumes are adequately captured.

==== After using: ====

* Clean any debris or waste from the inside of the hood.
* Unplug and store the hood and power supply together.
[[Category:Makerspace Tools]]

Tubing Washer - Revision history